FLASH TATTS®️ Directions for Use
You will be amazed by how quick and easy it is to apply your Flash Tattoos with help of a little water.
Step 1: Clean and dry skin. You want to make sure your skin is clean, dry and free of any oils or the tattoo will not adhere. If you have lotion or any products on (even from hours earlier), use a little soap and water or a cotton ball soaked in rubbing alcohol to clean the area.
Step 2: Cut out the tattoo as close to the edge as possible (this is important later when you need to line it up). If you are applying a band that will be worn as a bracelet, anklet or arm band, trim the tattoo to size if it needs to be adjusted while the protective liner is still in place.
Step 3: Once it is properly trimmed, remove the clear sheet. For best application, ask a friend to help position your Flash Tattoo so your skin does not twist or stretch.
Step 4: Place the tattoo face down on your skin and hold a wet cloth against it for about 30 seconds. Peel the paper aside then pat gently with the wet cloth. That's It! Be sure not to twist or stretch skin until the tattoo has had time to set (at least 20 minutes). Flash Tattoos look best after they have had an hour or two to set into the skin.
Remember to keep oil-based lotions, sunscreens, body wash, perfumes, etc. off your tatts!
**Please Note: FLASH TATTS®️ are Original Metallic Flash Temporary Tattoos from Sivalya. They are non toxic and safe for skin. However, if you have allergies to components please do not use them.